1.?? Harvest cells from a culture that is at or near peak density by centrifugation at ~800 x g for 5 min. Pool the cell pellets into a single tube.
2.?? Adjust the concentration of cells to 2.0 x 107/ml.? If the concentration is too low, centrifuge at ~800 x g for 5 minutes and resuspend the cell pellet with a volume of supernatant to yield the desired concentration.
3.?? Prepare a 10% (v/v) sterile DMSO solution in fresh medium as follows:? Add the required volume of DMSO to a glass screw-capped test tube and place on ice.? Allow the DMSO to solidify.? Add the required volume of refrigerated medium.? Dissolve the DMSO by inverting several times.? If the DMSO solution is not prepared on ice, an exothermic reaction will occur that may precipitate certain components of the medium.
4.?? Mix the cell preparation and the DMSO in equal portions. Thus, the final concentration will be 107 and 5% (v/v) DMSO. The time from the mixing of the cell preparation and DMSO stock solution to the start of the freezing process should be no less than 15 min and no longer than 60 min.
5.?? Dispense in 0.5 ml aliquots into 1.0 - 2.0 ml sterile plastic screw-capped cryules (special plastic vials for cryopreservation).
6.? Place vials in a controlled rate freezing unit. From room temperature cool at -1°C/min to -40°C. If freezing unit can compensate for the heat of fusion, maintain rate at -1 C/min through heat of fusion. At -40°C plunge ampules into liquid nitrogen.
7.?? The frozen preparations are stored in either the vapor or liquid phase of a nitrogen refrigerator.
8.?? To establish a culture from the frozen state place an ampule in a water bath set at 35°C. Immerse the vial enough to cover only the frozen material. Do not agitate the vial.
9.?? Immediately after thawing, do not leave in the water bath, aseptically remove the contents of the ampule and inoculate into 10.0 ml of fresh ATCC medium 1029.
10.????????? Incubate the tube at 20-25°C with the cap screwed on tightly.
